Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
On-Vehicle Inspection [12/2024 - ]: Procedure
- INSPECT FRONT ENGINE MOUNTING INSULATOR LH
Pre-procedure1
- w/ Cover:
- Remove the No. 2 engine under cover assembly.
HINT:
Refer to PROCEDURE - Step 11
- Remove the No. 2 engine under cover assembly.
- Disconnect the No. 4 ventilation hose from the front engine mounting insulator LH.
- Connect a vacuum pump to the front engine mounting insulator LH.
- Apply negative pressure of 80 kPa (600 mmHg, 23.6 in.Hg) absolute pressure and wait for 1 minute.
Standard
Vacuum pressure holds.
- Check if fluid leak from the front engine mounting insulator LH.
Standard
No fluid leak found.
- If the result is not as specified, replace the front engine mounting insulator LH.
Post-procedure1
- Disconnect the vacuum pump.
- Connect the No. 4 ventilation hose to the front engine mounting insulator LH.
- w/ Cover:
- Install the No. 2 engine under cover assembly.
HINT:
Refer to PROCEDURE - Step 49
- Install the No. 2 engine under cover assembly.
- w/ Cover:
- INSPECT FRONT ENGINE MOUNTING INSULATOR RH
Pre-procedure1
- w/ Cover:
- Remove the No. 2 engine under cover assembly.
HINT:
Refer to PROCEDURE - Step 11
- Remove the No. 2 engine under cover assembly.
- Disconnect the ventilation hose from the front engine mounting insulator RH.
- Connect a vacuum pump to the front engine mounting insulator RH.
- Apply negative pressure of 80 kPa (600 mmHg, 23.6 in.Hg) absolute pressure and wait for 1 minute.
Standard
Vacuum pressure holds.
- Check if fluid leak from the front engine mounting insulator RH.
Standard
No fluid leak found.
- If the result is not as specified, replace the front engine mounting insulator RH.
Post-procedure1
- Disconnect the vacuum pump.
- Connect the ventilation hose to the front engine mounting insulator RH.
- w/ Cover:
- Install the No. 2 engine under cover assembly.
HINT:
Refer to PROCEDURE - Step 49
- Install the No. 2 engine under cover assembly.
- w/ Cover:
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.