SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA20254RUNNER SR5, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (EXCEPT HEV) - DIAGNOSTIC CODES (P0606-P1378)SFI SYSTEM (FOR GASOLINE MODEL)DTC P0606-09: CONTROL MODULE PROCESSOR (BRAKE OVERRIDE SYSTEM OUTPUT SIGNAL) COMPONENT FAILURE [12/2024 - ]DESCRIPTION
2025 Toyota 4Runner SR5, RWD

DTC P0606-09: Control Module Processor (Brake Override System Output Signal) Component Failure [12/2024 - ]: Description

2025 Toyota 4Runner SR5, RWDSECTION Description
DTC No. Detection Item DTC Detection Condition Trouble Area MIL DTC Output from Priority Note
P0606-09 Control Module Processor (Brake Override System Output Signal) Component Failure Diagnosis condition:
When all of the following conditions are completed for approx. 3.5 seconds or longer
  • Accelerator opening 56.542°or more
  • STP signal is turned ON
  • Vehicle speed is over 40 km/h (25 mph)
  • Accelerator opening rate is not abnormal
  • STP is not abnormal
  • Wheel speed is not abnormal

Abnormal condition:
  • The accelerator opening command value after correction of the brake override system for control is excessively output more than the accelerator opening command value after correction of the monitoring brake override system

Abnormal period:
  • More than 1 second

Number of trips:
  • 1 trip

Detection method:
  • Constant monitor

Sensors/component parts used for detection:
  • Accelerator pedal sensor assembly
  • Stop light switch assembly
  • Speed sensor
 ECM Comes on Engine B SAE Code: P0606
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.