DTC U0100-87: Lost Communication with ECM/PCM "A" Missing Message; DTC U0101-87: Lost Communication with TCM Missing Message; DTC U0114-87: Lost Communication with Four-Wheel Drive Clutch Control Module Missing Message; DTC U0125-87: Lost Communication with Multi-axis Acceleration Sensor Module Missing Message; DTC U0126-87: Lost Communication with Steering Angle Sensor Module Missing Message; DTC U0131-87: Lost Communication With Power Steering Control Module Missing Message; DTC U0140-87: Lost Communication with Body Control Module Missing Message; DTC U0151-87: Lost Communication with Restraints Control Module Missing Message; DTC U115C-87: Lost Communication with ECM/PCM "A" (ch5) Missing Message [12/2024 - ]: Procedure

2025 Toyota 4Runner SR5, RWDSECTION Procedure
  1. CHECK DTC (HEALTH CHECK) 
    1. Perform the Health Check using the GTS.

      Result

      Result Proceed to
      DTCs other than CAN communication system DTCs are output. A
      Only CAN communication system DTCs are output. B
      None of the above conditions are met. C

    Result: 

    GO TO DIAGNOSTIC TROUBLE CODE CHART (RELATED SYSTEM) 

    Result: 

    REFER TO "CAN COMMUNICATION SYSTEM" 

    Result: 

    USE SIMULATION METHOD TO CHECK 

    Refer to METHOD TO SIMULATE PROBLEM SYMPTOMS [12/2024 - ]

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.