Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA20254RUNNER SR5, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM - SERVICE INFORMATIONTHROTTLE BODYINSPECTION [12/2024 - ]PROCEDURE
2025 Toyota 4Runner SR5, 4WD
Inspection [12/2024 - ]: Procedure
2025 Toyota 4Runner SR5, 4WDSECTION Procedure
- INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition Result 5 (M-) - 6 (M+) 20°C (68°F) 0.3 to 100 Ω Ω If the result is not as specified, replace the throttle body with motor assembly.
*a Component without harness connected
(Throttle Body with Motor Assembly)
- Measure the resistance according to the value(s) in the table below.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.