Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC B00C0-96: Passenger Seat Occupant Classification Sensor "A" Component Internal Failure [12/2024 - ]: Procedure
- CLEAR DTC
Pre-procedure1
- Turn the ignition switch to ON, and wait for at least 60 seconds.
Post-procedure1
- Turn the ignition switch off.
Result:
NEXT
See step 2
- CHECK DTC
Pre-procedure1
- Turn the ignition switch to ON, and wait for at least 60 seconds.
- Check the DTCs.
Body Electrical > SRS Airbag > Trouble Codes
Result
Result Proceed to B00C0-96 is output A B00C0-96 is not output B
Post-procedure1
- None
Result:
A
REPLACE FRONT SEAT ADJUSTER ASSEMBLY RH
for Manual Seat: Refer to REMOVAL [12/2024 - ]
for Power Seat: Refer to REMOVAL [12/2024 - ]
Result:
B
USE SIMULATION METHOD TO CHECK
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.