Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P1610-09: Control Module Processor (Brake Override System Input Signal) Component Failure [12/2024 - ]: Procedure
- CLEAR DTC
Pre-procedure1
- None.
Post-procedure1
- Turn the ignition switch off and wait for at least 30 seconds.
Result:
NEXT
See step 2
- READ OUTPUT DTC
Pre-procedure1
- Perform a confirmation drive. (Refer to confirmation drive in function description)
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A P1610-09 and other DTCs are output B P1610-09 is output C
Post-procedure1
- None.
Result:
A
CHECK FOR INTERMITTENT PROBLEMS
Refer to CHECK FOR INTERMITTENT PROBLEMS [12/2024 - ]
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2024 - ]
Result:
C
REPLACE ECM
Refer to REMOVAL [12/2024 - ]
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.