Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA20254RUNNER SR5, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEMSSTOP AND START SYSTEM - SERVICE INFORMATIONBACKUP BOOST CONVERTERREMOVAL [12/2024 - ]PROCEDURE

2025 Toyota 4Runner SR5, 4WD

Removal [12/2024 - ]: Procedure

2025 Toyota 4Runner SR5, 4WDSECTION Procedure

REMOVE FRONT FENDER LINER RH
Refer to DISASSEMBLY [12/2024 - ]

REMOVE ECO RUN VEHICLE CONVERTER ASSEMBLY

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Lock Lever	-	-
	Pull Up the Lock Lever	-	-

Move the lock lever as shown in the illustration and disconnect the eco run vehicle converter assembly connector.
Remove the 2 bolts and eco run vehicle converter assembly.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.