Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2013CAMRY SE, 2.5L ENG VIN FREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM (2AR-FE) (SERVICE INFORMATION) (EXCEPT HYBRID)THROTTLE BODYINSPECTIONINSPECTION
2013 Toyota Camry SE, 2.5L Eng VIN F
Throttle Body: Inspection: Inspection
2013 Toyota Camry SE, 2.5L Eng VIN FSECTION Inspection
- INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY
- Check that the throttle valve opens and closes smoothly.
- Check that there is no sludge accumulated around the throttle with motor body assembly.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 (M-) - 2 (M+) 20°C (68°F) 0.3 to 100 Ω TEXT IN ILLUSTRATION*a Component without harness connected:
(Throttle with Motor Body Assembly)If the result is not as specified, replace the throttle with motor body assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.