Service Data

2013 Toyota Camry SE, 2.5L Eng VIN FSECTION Service Data
Fuel pressure Standard fuel pressure 304 to 343 kPa (3.1 to 3.5 kgf/cm2 , 44 to 50 psi)
Fuel pressure : at fuel pressure remains for 5 minutes after engine has stopped Standard fuel pressure 147 kPa (1.5 kgf/cm2 , 21 psi) or more
Fuel injector assembly Standard resistance 11.6 to 12.4 Ω at 20°C (68°F)
Injection volume 87 to 105 cc (5.3 to 6.4 cu.in.) per 15 seconds
Difference between each fuel injector 18 cc (1.1 cu.in.) or less
Standard leakage 1 drop or less per 20 minutes
Fuel pump Standard resistance 0.2 to 3.0 Ω at 20°C (68°F)
Fuel sender gauge assembly Standard resistance 13.5 to 16.5 Ω(Float level F)
13.5 to 414.5 Ω(Float level E to F)
405.5 to 414.5 Ω(Float level E)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.