SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2013CAMRY SE, 2.5L ENG VIN FREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSPOWER WINDOW CONTROL SYSTEM (DIAGNOSTIC CODES & SYMPTOM TESTS) (EXCEPT HYBRID)POWER WINDOW CONTROL SYSTEMSYMPTOM TESTSJAM PROTECTION FUNCTION DOES NOT OPERATEPROCEDURE
2013 Toyota Camry SE, 2.5L Eng VIN F

Jam Protection Function does not Operate: Procedure

2013 Toyota Camry SE, 2.5L Eng VIN FSECTION Procedure
  1. PERFORM INITIALIZATION (DRIVER DOOR WINDOW MOTOR) 
    1. Initialize the power window regulator motor assembly LH (for driver door). Refer to INITIALIZATION .

    NEXT: Go to next step 

  2. CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (FOR DRIVER DOOR)) 
    1. Check if the power window auto up and down function operate normally. Refer to OPERATION CHECK .

      OK

      Driver door auto up and down function is normal.

    NG → See step   4 

    OK: Go to next step 

  3. CHECK JAM PROTECTION FUNCTION OPERATING RANGE 
    1. Check if the jam protection function operates normally for the driver door power window.

      HINT: 

      The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.

      OK

      Jam protection function operates normally.

    NG → See step   5 

    OK → END (PROBLEM DUE TO INITIALIZATION FAILURE) 

  4. GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table). Refer to  PROBLEM SYMPTOMS TABLE 
  5. REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (FOR DRIVER DOOR). Refer to  REMOVAL 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.