Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2013CAMRY SE, 2.5L ENG VIN FREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSSMART KEY SYSTEM (FOR ENTRY FUNCTION) (DIAGNOSTICS - INTRODUCTION) (EXCEPT HYBRID)SMART KEY SYSTEM (FOR ENTRY FUNCTION)PROBLEM SYMPTOMS TABLEPROBLEM SYMPTOMS TABLE
2013 Toyota Camry SE, 2.5L Eng VIN F
Problem Symptoms Table
2013 Toyota Camry SE, 2.5L Eng VIN FSECTION Problem Symptoms Table
HINT:
- If a problem occurs in certain locations or at certain times of day, check for the possibility of wave interference.
- When the electrical key transmitter sub-assembly is brought near the door control receiver (RF band), door outside handle (LF band), indoor electrical key antenna (LF band) or any of the electrical key antennas (LF band), the possibility of wave interference decreases. By doing this, whether wave interference is causing the problem can be checked.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
SMART KEY SYSTEM (FOR ENTRY FUNCTION)
| Symptom | Suspected Area | Refer To |
|---|---|---|
| Entry Interior Alarm does not Sound | Meter/gauge system | Refer to Entry Interior Alarm does not Sound |
| Certification ECU (smart key ECU assembly) | - | |
| All Door Entry Lock/Unlock Functions and Wireless Functions do not Operate | Power door lock control system | Refer to All Door Entry Lock/Unlock Functions and Wireless Functions do not Operate |
| Electrical key transmitter sub-assembly | - | |
| Transmitter battery | - | |
| Door control receiver | - | |
| Certification ECU (smart key ECU assembly) | - | |
| Harness or connector | - | |
| All Door Entry Lock/Unlock Functions do not Operate, but Wireless Functions Operate | Electrical key transmitter sub-assembly | Refer to All Door Entry Lock/Unlock Functions do not Operate, but Wireless Functions Operate |
| Certification ECU (smart key ECU assembly) | - | |
| Driver Door Entry Unlock Function does not Operate | Power door lock control system | Refer to Driver Side Door Entry Unlock Function does not Operate |
| Front door outside handle assembly (for driver door) | - | |
| Certification ECU (smart key ECU assembly) | - | |
| Harness or connector | - | |
| Front Passenger Door Entry Unlock Function does not Operate | Power door lock control system | Refer to Front Passenger Side Door Entry Unlock Function does not Operate |
| Front door outside handle assembly (for front passenger door) | - | |
| Certification ECU (smart key ECU assembly) | - | |
| Harness or connector | - | |
| Driver Door Entry Lock and Unlock Functions do not Operate | Power door lock control system | Refer to Driver Side Door Entry Lock and Unlock Functions do not Operate |
| Front door outside handle assembly (for driver door) | - | |
| Certification ECU (smart key ECU assembly) | - | |
| Harness or connector | - | |
| Front Passenger Door Entry Lock and Unlock Functions do not Operate | Power door lock control system | Refer to Front Passenger Side Door Entry Lock and Unlock Functions do not Operate |
| Front door outside handle assembly (for front passenger door) | - | |
| Certification ECU (smart key ECU assembly) | - | |
| Harness or connector | - | |
| Driver Door Entry Lock Function does not Operate | Power door lock control system | Refer to Driver Side Door Entry Lock Function does not Operate |
| Front door outside handle assembly (for driver door) | - | |
| Certification ECU (smart key ECU assembly) | - | |
| Harness or connector | - | |
| Front Passenger Door Entry Lock Function does not Operate | Power door lock control system | Refer to Front Passenger Side Door Entry Lock Function does not Operate |
| Front door outside handle assembly (for front passenger door) | - | |
| Certification ECU (smart key ECU assembly) | - | |
| Harness or connector | - | |
| Room Oscillator does not Recognize Key | Smart key system (for Start Function) | Refer to Room Oscillator does not Recognize Key |
| No. 1 indoor electrical key antenna (front floor) | - | |
| No. 2 indoor electrical key antenna (rear floor) | - | |
| Certification ECU (smart key ECU assembly) | - | |
| Harness or connector | - | |
| Electrical key transmitter sub-assembly | - | |
| Luggage Compartment Door Entry Unlock Function does not Operate when Key is Outside Luggage Compartment | Power door lock control system | Refer to Luggage Compartment Door Entry Unlock Function does not Operate when Key is Outside Luggage Compartment |
| Luggage Door Opening Switch Assembly | - | |
| Electrical key antenna (outside luggage) | - | |
| Certification ECU (smart key ECU assembly) | - | |
| Harness or connector | - | |
| Key Luggage Compartment Lock-in Prevention Function does not Operate | Power door lock control system | Refer to Key Luggage Compartment Lock-in Prevention Function does not Operate |
| No. 3 indoor electrical key antenna (inside luggage compartment) | - | |
| Certification ECU (smart key ECU assembly) | - | |
| Harness or connector | - | |
| New Key cannot be Registered | Steering Lock ECU (Steering Lock Actuator Assembly) | Refer to New Key cannot be Registered |
| Certification ECU (smart key ECU assembly) | - | |
| Engine Switch | - | |
| Harness or connector | - | |
| Additional Key cannot be Registered | Certification ECU (smart key ECU assembly) | Refer to Additional Key cannot be Registered |
| Electrical Key Transmitter Sub-assembly | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.