Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011YARIS L4-1.5L (1NZ-FE)REPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIRFRONT PASSENGER SIDE POWER WINDOW SWITCH (FOR HATCHBACK)INSTALLATION
2011 Toyota Yaris L4-1.5L (1NZ-FE)
Installation
2011 Toyota Yaris L4-1.5L (1NZ-FE)SECTION Installation
WINDSHIELD / WINDOWGLASS: FRONT PASSENGER SIDE POWER WINDOW SWITCH (for Hatchback): INSTALLATION
1. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY
(a) Engage the 2 claws and install the power window regulator switch.
2. INSTALL FRONT ARMREST BASE PANEL UPPER
(a) Connect the connector.
(b) Engage the 5 claws and clip and install the front armrest base panel upper.
3. INSTALL DOOR ARMREST COVER
HINT
Use the same procedure as for the LH side Reassembly.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.