Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2010VENZA AWD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - LIGHTING AND HORNSHEADLAMP ALIGNMENT CONTROL MODULESERVICE AND REPAIRAFS ECUREMOVAL
2010 Toyota Venza AWD V6-3.5L (2GR-FE)
Removal
2010 Toyota Venza AWD V6-3.5L (2GR-FE)SECTION Removal
LIGHTING (EXT): AFS ECU: REMOVAL
1. REMOVE SHIFT LEVER ASSEMBLY (for 2WD)
HINT
Refer to the procedure up to Remove Shift Lever Assembly .
2. REMOVE SHIFT LEVER ASSEMBLY (for AWD)
HINT
Refer to the procedure up to Remove Shift Lever Assembly Removal.
3. REMOVE AFS ECU
(a) Disconnect the connector.
(b) Remove the bolt.
(c) Disengage the guide and remove the AFS ECU.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.