Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2010VENZA AWD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMSPARK PLUGSERVICE AND REPAIRREMOVAL
2010 Toyota Venza AWD V6-3.5L (2GR-FE)
Removal
2010 Toyota Venza AWD V6-3.5L (2GR-FE)SECTION Removal
2GR-FE ENGINE CONTROL: IGNITION COIL AND SPARK PLUG: REMOVAL
1. REMOVE NO. 1 ENGINE UNDER COVER
2. REMOVE NO. 2 ENGINE UNDER COVER
3. DRAIN ENGINE COOLANT Service and Repair
4. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(a) Remove the windshield wiper motor and link assembly Removal.
5. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY Removal
6. REMOVE COOL AIR INTAKE DUCT SEAL Removal
7. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
8. REMOVE AIR CLEANER CAP WITH HOSE Removal
9. REMOVE INTAKE AIR SURGE TANK ASSEMBLY Removal
10. REMOVE NO. 1 SURGE TANK STAY Removal
11. REMOVE IGNITION COIL ASSEMBLY
(a) Disconnect the 3 wire harness clamps.
(b) Disconnect the 6 ignition coil connectors.
(c) Remove the 6 bolts and 6 ignition coils.
12. REMOVE SPARK PLUG
(a) Remove the 6 spark plugs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.