Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2010VENZA AWD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHTESTING AND INSPECTION
2010 Toyota Venza AWD V6-3.5L (2GR-FE)
Cruise Control Switch: Testing and Inspection
2010 Toyota Venza AWD V6-3.5L (2GR-FE)SECTION Testing and Inspection
CRUISE CONTROL: CRUISE CONTROL MAIN SWITCH: INSPECTION
1. INSPECT CRUISE CONTROL MAIN SWITCH
(a) for vehicles without vehicle-to-vehicle distance control mode:
(1) Measure the resistance according to the value(s) in the table below.
Text in Illustration:
Standard Resistance:
(2) *1: Lever is in neutral position
If the result is not as specified, replace the cruise control main switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.