Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2010VENZA AWD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHSERVICE AND REPAIRREMOVAL
2010 Toyota Venza AWD V6-3.5L (2GR-FE)
Removal
2010 Toyota Venza AWD V6-3.5L (2GR-FE)SECTION Removal
CRUISE CONTROL: CRUISE CONTROL MAIN SWITCH: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
2. REMOVE LOWER NO. 2 STEERING WHEEL COVER Removal
3. REMOVE LOWER NO. 3 STEERING WHEEL COVER Removal
4. REMOVE STEERING PAD Removal
5. REMOVE CRUISE CONTROL MAIN SWITCH
(a) Disconnect the connector.
(b) Remove the 2 screws and the cruise control main switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.