Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2003MATRIX XRS 2WD L4-1.8L (2ZZ-GE)REPAIR AND DIAGNOSISTECHNICAL SERVICE BULLETINSALL TECHNICAL SERVICE BULLETINSENGINE CONTROLS - BANK 1/BANK 2 O2 SENSOR IDENTIFICATION
2003 Toyota Matrix XRS 2WD L4-1.8L (2ZZ-GE)
Engine Controls - Bank 1/Bank 2 O2 Sensor identification
2003 Toyota Matrix XRS 2WD L4-1.8L (2ZZ-GE)SECTION Engine Controls - Bank 1/Bank 2 O2 Sensor identification
ENGINE
EG034-07
Title:
ENGINE BANK 1 AND BANK 2 A/F AND
O2 IDENTIFICATION
Models:
'93 - '08 Applicable Models
June 28, 2007
The information contained in this TSB supercedes TSB No. EG037-04. TSB No. EG037-04 is now obsolete and should be discarded.
Introduction
This service bulletin provides information on the proper identification of engine bank 1 and engine bank 2 for correct A/F sensor and oxygen sensor replacement.
This bulletin contains information that identifies engine bank 1 and engine bank 2 on the following engines: 1AZ-FE, 2AZ-FE, 2AZ-FE (PZEV), 1GR-FE, 2GR-FE, 2GR-FSE, 2JZ-GE, 1MZ-FE, 3MZ-FE, 1UR-FSE, 3UR-FE, 2UZ-FE, 3UZ-FE, 5VZ-FE, and 1ZZ-FE.
^ Bank 1 (B1) refers to the bank that includes cylinder No. 1.
^ Bank 2 (B2) refers to the bank opposite bank 1.
^ Sensor 1 (S1) refers to the sensor that is located before the catalytic converters.
^ Sensor 2 (S2) refers to the sensor that is located after the catalytic converters.
Warranty Information
Applicable Vehicles
Engine Bank Identification
A/F and 02 Sensor Identification
EG034-07
Title:
ENGINE BANK 1 AND BANK 2 A/F AND
O2 IDENTIFICATION
Models:
'93 - '08 Applicable Models
June 28, 2007
The information contained in this TSB supercedes TSB No. EG037-04. TSB No. EG037-04 is now obsolete and should be discarded.
Introduction
This service bulletin provides information on the proper identification of engine bank 1 and engine bank 2 for correct A/F sensor and oxygen sensor replacement.
This bulletin contains information that identifies engine bank 1 and engine bank 2 on the following engines: 1AZ-FE, 2AZ-FE, 2AZ-FE (PZEV), 1GR-FE, 2GR-FE, 2GR-FSE, 2JZ-GE, 1MZ-FE, 3MZ-FE, 1UR-FSE, 3UR-FE, 2UZ-FE, 3UZ-FE, 5VZ-FE, and 1ZZ-FE.
^ Bank 1 (B1) refers to the bank that includes cylinder No. 1.
^ Bank 2 (B2) refers to the bank opposite bank 1.
^ Sensor 1 (S1) refers to the sensor that is located before the catalytic converters.
^ Sensor 2 (S2) refers to the sensor that is located after the catalytic converters.
Warranty Information
Applicable Vehicles
Engine Bank Identification
A/F and 02 Sensor Identification
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.