Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA19904RUNNER 2D UTILITY, 3.0 V, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - TESTS W/CODES - V6
1990 Toyota 4Runner 2D Utility, 3.0 V, Standard
Engine Controls - Tests W/Codes - V6
1990 Toyota 4Runner 2D Utility, 3.0 V, StandardSECTION Engine Controls - Tests W/Codes - V6
- Introduction
- Ecu Location
- Hard Failures
- "Intermittent Failures"
- Check Engine Light
- Retrieving Trouble Codes
- Notes On Trouble Codes
- Clearing Trouble Codes
- Repair Procedure
- Summary
- Trouble Code Charts - EFI Models
- Diagnostic Hints - EFI Models
- Diagnostic Circuit Check
- Ecu Terminal Identification
- Test 1 Or Code 11 - Ecu (B+) Circuit
- Test 2 Or Code 12, 13, 14 - Ignition & Rpm Signal
- Test 3 Or Code 21 - Oxygen Sensor Signal
- Test 4 Or Code 22 - Coolant Temperature Sensor Signal
- Test 5 Or Code 24, 31, 32 - Air Temp Sensor/Airflow Meter
- Code 25 - Lean Air/Fuel Mixture
- Code 26 - Rich Air/Fuel Mixture
- Code 35 - HAC Sensor Signal
- Test 6 Or Code 41 - Throttle Position Sensor Signal
- Code 42 - Vehicle Speed Sensor Signal
- Test 7 Or Code 43 - Starter Signal
- Code 51 - Switch Signal
- Code 52 - Knock Sensor Signal
- Code 53 - Knock Sensor Control (Ecu)
- Test 8 Or Code 71 - EGR System Malfunction
- Test 9 - Injector Circuit
- Test 10 - Cold Start Injector Circuit
- Test 11 - Check Engine Light Circuit
- Test 12 - Stoplight Switch Circuit
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.