Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA19904RUNNER 2D UTILITY, 2.4 R, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROLS - SPECIFICATIONS - 4-CYLCAPACITIESCAMRY
1990 Toyota 4Runner 2D Utility, 2.4 R, Automatic
Engine Controls - Specifications - 4-CYL: Capacities: CAMRY
1990 Toyota 4Runner 2D Utility, 2.4 R, AutomaticSECTION CAMRY
FLUID CAPACITIES - CAMRY
| Application | Qts. (L) | |||||||
|---|---|---|---|---|---|---|---|---|
| Crankcase (Includes Filter) | 4.3 (4.1) | |||||||
| Cooling System (Includes Heater) | ||||||||
| Man. Trans | 6.8 (6.4) | |||||||
| 2WD Auto. Trans. | 6.7 (6.3) | |||||||
| 4WD Auto. Trans. | 7.2 (6.8) | |||||||
| Automatic Transaxle (1) | ||||||||
| Transaxle | ||||||||
| 2WD (Dexron-II) | 2.6 (2.5) | |||||||
| All Trac (Type "T" (2)) | 3.5 (3.3) | |||||||
| Differential | ||||||||
| 2WD, 3S-FE (Dexron-II) | 1.7 (1.6) | |||||||
| All Trac | ||||||||
| Front (SAE 75W-90 W/ GL-5 Rating) | .74 (.70) | |||||||
| Rear (SAE 90 W/ GL-5 Rating) | 1.2 (1.1) | |||||||
| Manual Transaxle | ||||||||
| Transaxle | ||||||||
| 2WD, (Dexron-II) | 2.7 (2.6) | |||||||
| All Trac (SAE 75W-90 W/ GL-5 Rating) | 5.2 (5.0) | |||||||
| Differential | ||||||||
| All Trac (Rear) | 1.2 (1.1) | |||||||
|
||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.