Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA19904RUNNER 2D UTILITY, 2.4 R, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCHARGING SYSTEMSALTERNATOR & REGULATORON-VEHICLE TESTINGLOAD TEST
1990 Toyota 4Runner 2D Utility, 2.4 R, Automatic
Load Test
1990 Toyota 4Runner 2D Utility, 2.4 R, AutomaticSECTION Load Test
NOTE:
During load test procedure, if voltage reading is low due to a fully charged battery, disable ignition system and crank engine for about 15 seconds to partially discharge battery (if necessary).
- Connect an ammeter as described in NO-LOAD TEST step 1). Start engine. Turn on high beam headlights and place heater control on HI.
- Increase engine speed to 2000 RPM and check ammeter reading. Ammeter should read more than 30 amps. If amperage is less than specified, repair or replace alternator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.