Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA19904RUNNER 2D UTILITY, 2.4 R, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESDRIVE AXLE - AUTOMATIC DISCONNECTINGCOMPONENT TESTINGADD INDICATOR SWITCH
1990 Toyota 4Runner 2D Utility, 2.4 R, Automatic
Add Indicator Switch
1990 Toyota 4Runner 2D Utility, 2.4 R, AutomaticSECTION Add Indicator Switch
- Remove ADD indicator switch. See ADD INDICATOR SWITCH under REMOVAL & INSTALLATION. Fully depress pin on end of ADD indicator switch. Using ohmmeter, ensure continuity exists between electrical terminals on ADD indicator switch with pin depressed.
- Release pin of end of ADD indicator switch. Ensure no continuity now exists between electrical terminals on ADD indicator switch. Replace ADD switch if defective.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.