Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI1999ESTEEM GLX SEDAN L4-1.6LREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION SWITCHTESTING AND INSPECTION
1999 Suzuki Esteem GLX Sedan L4-1.6L
Ignition Switch: Testing and Inspection
1999 Suzuki Esteem GLX Sedan L4-1.6LSECTION Testing and Inspection
IGNITION (MAIN) SWITCH
1. Disconnect negative (-) cable a battery
2. Disable air bag system.
3. Disconnect main switch lead wire connectors from junction/fuse block and air bag harness.
CHECKING CONTINUITY BETWEEN TERMINALS
Use a circuit tester to check the continuity at each switch position.
If any continuity is not obtained, replace main switch.
ACC: Accessory
1. Disconnect negative (-) cable a battery
2. Disable air bag system.
3. Disconnect main switch lead wire connectors from junction/fuse block and air bag harness.
CHECKING CONTINUITY BETWEEN TERMINALS
Use a circuit tester to check the continuity at each switch position.
If any continuity is not obtained, replace main switch.
ACC: Accessory
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.