Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI1999ESTEEM GLX SEDAN L4-1.6LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSSERVICE AND REPAIRFUEL LEAKAGE CHECK PROCEDURE
1999 Suzuki Esteem GLX Sedan L4-1.6L
Fuel Leakage Check Procedure
1999 Suzuki Esteem GLX Sedan L4-1.6LSECTION Fuel Leakage Check Procedure
FUEL LEAKAGE CHECK PROCEDURE
After performing any service on fuel system, check to make sure that there are no fuel leakages as follows.
1. Turn ON ignition switch for 3 seconds (to operate fuel pump) and then turn it OFF.
Repeat this (ON and OFF) 3 or 4 times and apply fuel pressure to fuel line (till fuel pressure is felt by hand placed on fuel return hose.)
2. In this state, check to see that there are no fuel leakages from any part of fuel system.
After performing any service on fuel system, check to make sure that there are no fuel leakages as follows.
1. Turn ON ignition switch for 3 seconds (to operate fuel pump) and then turn it OFF.
Repeat this (ON and OFF) 3 or 4 times and apply fuel pressure to fuel line (till fuel pressure is felt by hand placed on fuel return hose.)
2. In this state, check to see that there are no fuel leakages from any part of fuel system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.