Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI1999ESTEEM GLX SEDAN L4-1.6LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSSENSORS AND SWITCHES - COMPUTERS AND CONTROL SYSTEMSTRANSMISSION POSITION SENSOR/SWITCHTESTING AND INSPECTION
1999 Suzuki Esteem GLX Sedan L4-1.6L
Transmission Position Sensor/Switch: Testing and Inspection
1999 Suzuki Esteem GLX Sedan L4-1.6LSECTION Testing and Inspection
INSPECTION
1. Disconnect transmission range sensor at connector.
2. At each of P, R, N, D, 2 and L shift position, check continuity between terminals as well as each terminal and switch case. Continuity should be indicated only between those terminals as shown in table at each shift position. Continuity should not exist between any terminal and switch case. If malfunction is found, adjust or replace.
1. Disconnect transmission range sensor at connector.
2. At each of P, R, N, D, 2 and L shift position, check continuity between terminals as well as each terminal and switch case. Continuity should be indicated only between those terminals as shown in table at each shift position. Continuity should not exist between any terminal and switch case. If malfunction is found, adjust or replace.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.