Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI1998ESTEEM GLX SEDAN PLUS L4-1.6LREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SERVOSERVICE AND REPAIR
1998 Suzuki Esteem GLX Sedan Plus L4-1.6L
Cruise Control Servo: Service and Repair
1998 Suzuki Esteem GLX Sedan Plus L4-1.6LSECTION Service and Repair
CRUISE CONTROL ACTUATOR ASSEMBLY (WITH CONTROL MODULE)
CAUTION: Never disassemble cruise control actuator assembly. Disassembly will spoil its original function.
Removal
1) Disconnect negative cable from battery.
2) Disconnect connector from actuator assembly (with control module).
3) Remove actuator cap from actuator assembly.
4) Disconnect cruise cable from actuator assembly.
5) Remove actuator assembly from vehicle.
Inspection
Move actuator lever by hand and check its operation as described below.
1) Actuator lever should not turn clockwise.
2) Actuator lever should turn smoothly by about 1/3 rotation counterclockwise and contact internal stopper.
3) When hand is taken off from actuator lever at the position in 2) above, it should return to its original position by return spring force. If actuator lever does not operate as described above, replace it.
Installation
Install actuator assembly by reversing removal procedure, noting following point.
- Adjust cruise cable play to specification referring to "cruise cable".
CAUTION: Never disassemble cruise control actuator assembly. Disassembly will spoil its original function.
Removal
1) Disconnect negative cable from battery.
2) Disconnect connector from actuator assembly (with control module).
3) Remove actuator cap from actuator assembly.
4) Disconnect cruise cable from actuator assembly.
5) Remove actuator assembly from vehicle.
Inspection
Move actuator lever by hand and check its operation as described below.
1) Actuator lever should not turn clockwise.
2) Actuator lever should turn smoothly by about 1/3 rotation counterclockwise and contact internal stopper.
3) When hand is taken off from actuator lever at the position in 2) above, it should return to its original position by return spring force. If actuator lever does not operate as described above, replace it.
Installation
Install actuator assembly by reversing removal procedure, noting following point.
- Adjust cruise cable play to specification referring to "cruise cable".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.