Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2010OUTBACK SPORT F4-2.5L SOHCREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSAUTOMATIC TRANSMISSION/TRANSAXLESYSTEM SPECIFICATIONSFLEX PLATE
2010 Subaru Outback Sport F4-2.5L SOHC
Flex Plate
2010 Subaru Outback Sport F4-2.5L SOHCSECTION Flex Plate
Drive Plate
Temporarily tighten 10 Nm (1.0 kgf-m, 7.4 ft-lb)
Additionally tighten 40 Nm (4.1 kgf-m, 29.5 ft-lb)
Further tighten 30 degrees ± 5 degrees
Temporarily tighten 10 Nm (1.0 kgf-m, 7.4 ft-lb)
Additionally tighten 40 Nm (4.1 kgf-m, 29.5 ft-lb)
Further tighten 30 degrees ± 5 degrees
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.