Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2010OUTBACK SPORT F4-2.5L SOHCREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - RESTRAINTS AND SAFETY SYSTEMSAIR BAG CONTROL MODULESERVICE AND REPAIR
2010 Subaru Outback Sport F4-2.5L SOHC
Air Bag Control Module: Service and Repair
2010 Subaru Outback Sport F4-2.5L SOHCSECTION Service and Repair
Airbag Control Module
REMOVAL
CAUTION:
- Do not disassemble the airbag control module.
- If the airbag control module is deformed or if the damage from water is suspected, replace the airbag control module with a new part.
- Do not drop the airbag control module.
- After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.
1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove the console box.
4. Remove the center panel.
5. Remove the console front panel.
6. Remove the audio.
7. Remove the heater duct.
8. Disconnect the connector from airbag control module.
9. Remove the three bolts and remove airbag control module.
INSTALLATION
CAUTION:
- Do not reuse the bolt and nut. Always use new bolts and nuts for them.
- Before installing the audio, make sure that the heater duct is securely connected.
Install in the reverse order of removal.
Tightening torque: 25 N.m (2.55 kgf-m, 18.4 ft-lb)
REMOVAL
CAUTION:
- Do not disassemble the airbag control module.
- If the airbag control module is deformed or if the damage from water is suspected, replace the airbag control module with a new part.
- Do not drop the airbag control module.
- After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.
1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove the console box.
4. Remove the center panel.
5. Remove the console front panel.
6. Remove the audio.
7. Remove the heater duct.
8. Disconnect the connector from airbag control module.
9. Remove the three bolts and remove airbag control module.
INSTALLATION
CAUTION:
- Do not reuse the bolt and nut. Always use new bolts and nuts for them.
- Before installing the audio, make sure that the heater duct is securely connected.
Install in the reverse order of removal.
Tightening torque: 25 N.m (2.55 kgf-m, 18.4 ft-lb)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.