Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2010OUTBACK SPORT F4-2.5L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMIGNITION TIMINGTESTING AND INSPECTION
2010 Subaru Outback Sport F4-2.5L SOHC
Ignition Timing: Testing and Inspection
2010 Subaru Outback Sport F4-2.5L SOHCSECTION Testing and Inspection
Ignition Timing
INSPECTION
CAUTION:
After warming-up, engine becomes very hot. Be careful not to burn yourself at measurement.
1) Before checking the ignition timing, check the following item:
1) Check the air cleaner element is free from clogging, spark plugs are in good condition, and hoses are connected properly.
2) Check the malfunction indicator light does not illuminate.
2) Warm up the engine.
3) Stop the engine, and turn the ignition switch to OFF.
4) Connect the timing light to #1 cylinder spark plug cord, and then light the timing mark with the timing light.
5) Start the engine and check the ignition timing at idle speed as shown below.
If the timing is not correct, check the ignition control system.
INSPECTION
CAUTION:
After warming-up, engine becomes very hot. Be careful not to burn yourself at measurement.
1) Before checking the ignition timing, check the following item:
1) Check the air cleaner element is free from clogging, spark plugs are in good condition, and hoses are connected properly.
2) Check the malfunction indicator light does not illuminate.
2) Warm up the engine.
3) Stop the engine, and turn the ignition switch to OFF.
4) Connect the timing light to #1 cylinder spark plug cord, and then light the timing mark with the timing light.
5) Start the engine and check the ignition timing at idle speed as shown below.
If the timing is not correct, check the ignition control system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.