Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2010OUTBACK SPORT F4-2.5L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCRANKSHAFT POSITION SENSORSERVICE AND REPAIR
2010 Subaru Outback Sport F4-2.5L SOHC
Crankshaft Position Sensor: Service and Repair
2010 Subaru Outback Sport F4-2.5L SOHCSECTION Service and Repair
Crankshaft Position Sensor
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the bolt which secures crankshaft position sensor to cylinder block.
3. Remove the crankshaft position sensor, and then disconnect the connector from it.
INSTALLATION
Install in the reverse order of removal.
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the bolt which secures crankshaft position sensor to cylinder block.
3. Remove the crankshaft position sensor, and then disconnect the connector from it.
INSTALLATION
Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.