Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2010OUTBACK SPORT F4-2.5L SOHCREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGSERVICE AND REPAIRREFRIGERANT RECOVERY PROCEDURE
2010 Subaru Outback Sport F4-2.5L SOHC
Refrigerant Recovery Procedure
2010 Subaru Outback Sport F4-2.5L SOHCSECTION Refrigerant Recovery Procedure
Refrigerant Recovery Procedure
PROCEDURE
CAUTION:
- During operation, be sure to wear protective goggles and protective gloves.
- Connect the refrigerant recovery system with the manifold gauge set to discharge the refrigerant from the A/C system and recycle the gas.
- When recycling the discharged refrigerant, keep service cans on hand. Because the recovery rate with the recovery system is approx. 90%, service cans are necessary to charge the refrigerant.
- Follow the detailed operation procedure described in the operation manual attached to the refrigerant recovery system.
1. Perform compressor oil return operation.
2. Stop the engine.
3. Make sure the valves on low/high pressure sides of manifold gauge set are fully closed.
4. Install the low/high pressure hoses to the service ports on the low/high pressure sides of the vehicle respectively.
5. Connect the center hose to the refrigerant recovery system.
6. Follow the operation manual to activate the refrigerant recovery system.
PROCEDURE
CAUTION:
- During operation, be sure to wear protective goggles and protective gloves.
- Connect the refrigerant recovery system with the manifold gauge set to discharge the refrigerant from the A/C system and recycle the gas.
- When recycling the discharged refrigerant, keep service cans on hand. Because the recovery rate with the recovery system is approx. 90%, service cans are necessary to charge the refrigerant.
- Follow the detailed operation procedure described in the operation manual attached to the refrigerant recovery system.
1. Perform compressor oil return operation.
2. Stop the engine.
3. Make sure the valves on low/high pressure sides of manifold gauge set are fully closed.
4. Install the low/high pressure hoses to the service ports on the low/high pressure sides of the vehicle respectively.
5. Connect the center hose to the refrigerant recovery system.
6. Follow the operation manual to activate the refrigerant recovery system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.