Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2002LEGACY L SEDAN AWD F4-2.5L SOHCREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION LOCKTESTING AND INSPECTION
2002 Subaru Legacy L Sedan AWD F4-2.5L SOHC
Ignition Lock: Testing and Inspection
2002 Subaru Legacy L Sedan AWD F4-2.5L SOHCSECTION Testing and Inspection
INSPECTION
1. Remove the instrument panel lower cover.
2. Remove the lower column cover.
3. Unfasten the hold-down clip which secures the harness and disconnect the connector of the ignition switch from the body harness.
4. Turn the ignition key plate to each position and check the continuity between the terminals of the ignition connector.
If NG, replace the ignition switch.
1. Remove the instrument panel lower cover.
2. Remove the lower column cover.
3. Unfasten the hold-down clip which secures the harness and disconnect the connector of the ignition switch from the body harness.
4. Turn the ignition key plate to each position and check the continuity between the terminals of the ignition connector.
If NG, replace the ignition switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.