Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1998LEGACY OUTBACK SPORT AWD F4-2.2L SOHCREPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSAIR BAG SYSTEMSAIR BAG CONTROL MODULESERVICE AND REPAIR
1998 Subaru Legacy Outback Sport AWD F4-2.2L SOHC
Air Bag Control Module: Service and Repair
1998 Subaru Legacy Outback Sport AWD F4-2.2L SOHCSECTION Service and Repair
Airbag Control Module
REMOVAL AND INSTALLATION
CAUTION:
- Do not disassemble the airbag control module.
- If the airbag control module is deformed, or if water damage is suspected, replace the airbag control module with a new genuine part.
- After removal, keep the airbag control module on a dry, clean surface away from heat and light sources, and moisture and dust.
1. Turn ignition switch off.
2. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove lower cover. Disconnect airbag connector (AB3) and (AB8) below steering column.
CAUTION: Do not reconnect airbag connector at steering column until airbag control module is securely re-installed.
4. Remove console box.
5. Disconnect connector from airbag control module.
6. Using TORX© BIT T40 (Tamper resistant type), remove two TORX© bolts. Discard the old TORX© bolts.
CAUTION: Use new TORX© bolts during re-assembly.
7. Installation is in the reverse order of removal.
REMOVAL AND INSTALLATION
CAUTION:
- Do not disassemble the airbag control module.
- If the airbag control module is deformed, or if water damage is suspected, replace the airbag control module with a new genuine part.
- After removal, keep the airbag control module on a dry, clean surface away from heat and light sources, and moisture and dust.
1. Turn ignition switch off.
2. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove lower cover. Disconnect airbag connector (AB3) and (AB8) below steering column.
CAUTION: Do not reconnect airbag connector at steering column until airbag control module is securely re-installed.
4. Remove console box.
5. Disconnect connector from airbag control module.
6. Using TORX© BIT T40 (Tamper resistant type), remove two TORX© bolts. Discard the old TORX© bolts.
CAUTION: Use new TORX© bolts during re-assembly.
7. Installation is in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.