Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1998LEGACY OUTBACK SPORT AWD F4-2.2L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTRANSMISSION POSITION SENSOR/SWITCHDESCRIPTION AND OPERATION
1998 Subaru Legacy Outback Sport AWD F4-2.2L SOHC
Transmission Position Sensor/Switch: Description and Operation
1998 Subaru Legacy Outback Sport AWD F4-2.2L SOHCSECTION Description and Operation
INHIBITOR SWITCH
- The inhibitor switch assures safety when starting the engine. this switch is mounted on the right side of the transmission case, and is operated by the range selector lever.
- When the selector lever is set to "P" or "N",the electrical circuit is connected in the inhibitor switch and the starter circuit is energized for cranking the engine.
- When the selector lever is set to "R", "D","3" "2", or "1" range, the electrical circuit is disconnected in the inhibitor switch. hence engine cranking is disabled. In the "R" range, the backup light circuit is completed in the switch, and the backup lights come on.
- In addition to the above function, the inhibitor switch incorporates a circuit for detecting the selected range position and sending the range signal to the Transmission Control Module (TCM).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.