Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1996LEGACY WAGON 4WD F4-2.2L SOHCREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BRAKES AND TRACTION CONTROLELECTRONIC BRAKE CONTROL MODULESERVICE AND REPAIRABS/TCS CONTROL MODULEREMOVAL
1996 Subaru Legacy Wagon 4WD F4-2.2L SOHC
Removal
1996 Subaru Legacy Wagon 4WD F4-2.2L SOHCSECTION Removal
REMOVAL
1) Disconnect ground cable from battery.
2) Remove floor mat located under lower right side of front seat.
3) Remove screw which secure ABS/TCS control module from the body.
4) Disconnect connector from ABS/TCS control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.