Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1996LEGACY WAGON 4WD F4-2.2L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - IGNITION SYSTEMIGNITION CONTROL MODULEDESCRIPTION AND OPERATION
1996 Subaru Legacy Wagon 4WD F4-2.2L SOHC
Ignition Control Module: Description and Operation
1996 Subaru Legacy Wagon 4WD F4-2.2L SOHCSECTION Description and Operation
PURPOSE/OPERATION
Controls ignition discharge by interrupting the ignition coil primary current ground. The igniter is a switching device used to interrupt the ignition coil ground connection and induce high voltage from the coil secondary windings. A signal from the ECM controls igniter switching, enabling the ECM to regulate ignition timing based engine operating condition information received from various sensors.
Controls ignition discharge by interrupting the ignition coil primary current ground. The igniter is a switching device used to interrupt the ignition coil ground connection and induce high voltage from the coil secondary windings. A signal from the ECM controls igniter switching, enabling the ECM to regulate ignition timing based engine operating condition information received from various sensors.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.