Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2002SL1 L4-1.9L SOHC VIN 8REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - CRUISE CONTROLCRUISE CONTROL MODULEADJUSTMENTSCRUISE CONTROL MODULE ROD ADJUSTMENT - (RHD DOMESTIC)
2002 Saturn SL1 L4-1.9L SOHC VIN 8
Cruise Control Module Rod Adjustment - (RHD Domestic)
2002 Saturn SL1 L4-1.9L SOHC VIN 8SECTION Cruise Control Module Rod Adjustment - (RHD Domestic)
Cruise Control Module Rod Adjustment - (RHD DOMESTIC):
1. Observe position of throttle linkage to make sure the linkage is resting on the throttle stop screw.
2. Depress cruise cable adjuster release tabs and slide adjuster away from the module.
3. Ignition On, engine Off.
4. Using Scan tool, note TP sensor voltage.
NOTE: Driveability concerns may result if the cruise control rod is not adjusted properly.
IMPORTANT: 1-2 mm (0.040-0.079 in.) is approximately one click movement of the adjuster.
5. Move adjuster in toward module until a 1-2 mm (0.040-0.079 in.) clearance is between the adjuster and the accelerator pedal bracket. There should be a very slight amount of play in the accelerator cable.
6. Using Scan tool, make sure TP sensor voltage is not greater than the voltage noted before the adjustment procedure was performed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.