Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2002SL1 L4-1.9L SOHC VIN 8REPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSELECTRONIC BRAKE CONTROL MODULESERVICE AND REPAIRABS CONTROL ASSEMBLY
2002 Saturn SL1 L4-1.9L SOHC VIN 8
ABS Control Assembly
2002 Saturn SL1 L4-1.9L SOHC VIN 8SECTION ABS Control Assembly
ABS CONTROL ASSEMBLY
REMOVAL
1. Remove air cleaner housing cover and air induction hose at throttle body.
2. Remove powertrain control module bolts.
3. Disconnect powertrain control module I/P harness electrical connector.
4. Lift powertrain control module from carrier and set aside.
IMPORTANT: Clean all exterior surfaces with brake cleaner.
5. Disconnect control module electrical connector by pulling on lock tab.
6. Remove control module screws.
7. Pull control module straight off of valve assembly.
INSTALLATION
1. Align coils on electronic brake and traction control module with valve cores on brake pressure modulator valve assembly and push together.
2. Install and tighten screws.
Torque: Control Module-to-Valve Assembly Screws: 4 - 6 Nm (35 - 53 inch lbs.)
3. Connect electrical connector and push in tab to lock.
4. Install powertrain control module to carrier.
5. Connect powertrain control module I/P harness electrical connector.
6. Install and tighten PCM attachment bolts.
Torque: PCM Attachment Bolts: 6 Nm (53 inch lbs.)
7. Install air cleaner housing cover and air induction hose.
REMOVAL
1. Remove air cleaner housing cover and air induction hose at throttle body.
2. Remove powertrain control module bolts.
3. Disconnect powertrain control module I/P harness electrical connector.
4. Lift powertrain control module from carrier and set aside.
IMPORTANT: Clean all exterior surfaces with brake cleaner.
5. Disconnect control module electrical connector by pulling on lock tab.
6. Remove control module screws.
7. Pull control module straight off of valve assembly.
INSTALLATION
1. Align coils on electronic brake and traction control module with valve cores on brake pressure modulator valve assembly and push together.
2. Install and tighten screws.
Torque: Control Module-to-Valve Assembly Screws: 4 - 6 Nm (35 - 53 inch lbs.)
3. Connect electrical connector and push in tab to lock.
4. Install powertrain control module to carrier.
5. Connect powertrain control module I/P harness electrical connector.
6. Install and tighten PCM attachment bolts.
Torque: PCM Attachment Bolts: 6 Nm (53 inch lbs.)
7. Install air cleaner housing cover and air induction hose.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.