Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1998SL2 L4-1.9L DOHC VIN 7REPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIRPOWER WINDOW/MIRROR SWITCH
1998 Saturn SL2 L4-1.9L DOHC VIN 7
Power Window/Mirror Switch
1998 Saturn SL2 L4-1.9L DOHC VIN 7SECTION Power Window/Mirror Switch
Power Window/Mirror Switch: Removal/Installation:
REMOVAL
1. Slide switch assembly forward.
2. Using a small flat bladed screw driver, carefully lift switch at rear edge.
3. Lift switch from console.
4. Disconnect electrical connector.
INSTALLATION
1. Connect electrical connectors.
2. Start front of switch assembly into console, press down into place.
3. Check operation of all switches.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.