Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1998SL2 L4-1.9L DOHC VIN 7REPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIRPOWER WINDOW REAR DOOR SWITCH
1998 Saturn SL2 L4-1.9L DOHC VIN 7
Power Window Rear Door Switch
1998 Saturn SL2 L4-1.9L DOHC VIN 7SECTION Power Window Rear Door Switch
Power Window Rear Door Switch: Removal/Installation:
REMOVAL
1. Remove screw from center of inside door handle assembly.
2. Slide door handle assembly forward while pulling outward from trim panel.
3. Disconnect electrical connector.
4. Remove switch from door handle assembly by releasing retainer tabs.
INSTALLATION
1. Install switch to door handle assembly.
2. Connect electrical connector.
3. Position door handle assembly into trim panel.
4. Install screw in handle and tighten
5. Check operation switch.
Torque: 2.5 N^m (22 in-lbs)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.