Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1998SL2 L4-1.9L DOHC VIN 7REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - CRUISE CONTROLCRUISE CONTROL MODULESERVICE AND REPAIRRIGHT HAND DRIVE
1998 Saturn SL2 L4-1.9L DOHC VIN 7
Right Hand Drive
1998 Saturn SL2 L4-1.9L DOHC VIN 7SECTION Right Hand Drive
Description:
Before replacing brake switch, check brake switch adjustment. With the brake depressed, the brake switch contacts should be open (no continuity). With the brake released the brake switch contacts should be closed (continuity).
The brake switch can be adjusted by loosening the bolt and sliding it towards, or away from the brake pedal. The plunger should be fully depressed with the brake pedal released.
REMOVAL
1. Turn ignition Off.
2. Disconnect electrical connector to brake switch.
3. Remove bolt from brake switch and remove brake switch.
INSTALLATION
1. Position brake switch to vehicle and install bolt.
NOTICE: There is a tab on the brake switch that fits into a slotted hole. This tab keeps the brake switch parallel to the brake pedal. Before tightening the bolt, be sure that the plunger is fully depressed with the brake pedal released.
Torque: 10 NM (89 in. lbs)
2. Connect electrical connector to brake switch.
3. Adjust brake switch assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.