Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1998SL2 L4-1.9L DOHC VIN 7REPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSELECTRONIC BRAKE CONTROL MODULESERVICE AND REPAIRABS/PCM BRACKET
1998 Saturn SL2 L4-1.9L DOHC VIN 7
ABS/PCM Bracket
1998 Saturn SL2 L4-1.9L DOHC VIN 7SECTION ABS/PCM Bracket
REMOVAL
1. Remove ABS control module. Refer to ABS Control Module.
2. Disconnect PCM connectors from under I/P.
3. Loosen PCM attachment nut at cross car beam and lift PCM upward (towards windshield) to disengage ABS/PCM bracket.
NOTICE: Do not pull on the connectors or wires to remove the PCM. This could back out a terminal and cause an intermittent connection.
4. Remove nuts holding ABS/PCM bracket to steering column support bracket.
5. Remove ABS/PCM bracket.
INSTALLATION
1. Install ABS/PCM bracket stud through hole in steering column support bracket.
2. Install and torque nut.
^ Torque: 6 Nm (54 in. lbs.)
3. Lower PCM into bracket while guiding attachment stud into slot in cross car beam.
NOTICE: Torque is critical to preserve the integrity of the plastic insulator on the PCM case. Damage to the PCM can result from over torque of the nut.
4. Torque nut.
^ Torque: 10 Nm (89 in. lbs.)
5. Connect PCM electrical connectors.
6. Install ABS control module. Refer to ABS Control Module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.