Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1996SC2 L4-1.9L DOHC VIN 7REPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW REGULATORSERVICE AND REPAIRWINDOW REGULATOR ASSEMBLY
1996 Saturn SC2 L4-1.9L DOHC VIN 7
Window Regulator Assembly
1996 Saturn SC2 L4-1.9L DOHC VIN 7SECTION Window Regulator Assembly
REMOVAL
1. Remove inner door trim panel.
2. Remove outer door panel.
3. Lower door glass.
Remove glass nuts with tool SA9148B.
Push glass up and rotate slightly.
Remove door glass.
4. Disconnect harness on power regulator.
5. Remove regulator cam bolts.
Drill out regulator rivets and remove regulator.
INSTALLATION
1. Install regulator with rivets.
Install regulator cam bolts.
2. Connect harness on power regulator.
3. Install door glass into door and over regulator studs.
Install glass nut with tool SA9148B.
Torque: 6 N.m (53 in.lbs.)
4. Adjust door glass.
5. Install outer door panel.
6. Install inner door trim panel.
1. Remove inner door trim panel.
2. Remove outer door panel.
3. Lower door glass.
Remove glass nuts with tool SA9148B.
Push glass up and rotate slightly.
Remove door glass.
4. Disconnect harness on power regulator.
5. Remove regulator cam bolts.
Drill out regulator rivets and remove regulator.
INSTALLATION
1. Install regulator with rivets.
Install regulator cam bolts.
2. Connect harness on power regulator.
3. Install door glass into door and over regulator studs.
Install glass nut with tool SA9148B.
Torque: 6 N.m (53 in.lbs.)
4. Adjust door glass.
5. Install outer door panel.
6. Install inner door trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.