Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1996SC2 L4-1.9L DOHC VIN 7REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - INSTRUMENT PANELAUDIBLE WARNING DEVICE CONTROL MODULESERVICE AND REPAIR
1996 Saturn SC2 L4-1.9L DOHC VIN 7
Audible Warning Device Control Module: Service and Repair
1996 Saturn SC2 L4-1.9L DOHC VIN 7SECTION Service and Repair
Chime Module:
REMOVAL
1. Remove driver's side close-out panel to expose I/P junction block.
2. Press lock tab on the bottom side of the chime module to release connector from I/P chime module.
3. Carefully pull out chime module.
INSTALLATION
1. Carefully plug the chime module into the I/P junction block until it locks into place.
2. Install driver's side close-out panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.