SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1996SC2 L4-1.9L DOHC VIN 7REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSSENSORS AND SWITCHES - COMPUTERS AND CONTROL SYSTEMSTHROTTLE POSITION SENSORSERVICE AND REPAIR
1996 Saturn SC2 L4-1.9L DOHC VIN 7

Throttle Position Sensor: Service and Repair

1996 Saturn SC2 L4-1.9L DOHC VIN 7SECTION Service and Repair

Throttle Position Sensor On Side Of Throttle Body:







REMOVAL

1. Turn ignition Off.
2. Remove air intake tube and resonator.
3. Remove electrical connector from the sensor.
4. Remove TP sensor bolts.
5. Remove TP sensor assembly from throttle body.

NOTE: The TP sensor is an electrical component, and must not be soaked in any liquid solvent; otherwise damage could result.


INSTALLATION

1. With throttle valve closed, install TP sensor on throttle shaft. Rotate counterclockwise to align mounting holes.
2. Install bolts.
- Torque: 2 N.m (18 in-lbs)
3. Connect electrical connector to TP sensor. Push in until a click is heard and pull back to confirm a positive engagement.
4. Install intake tube and resonator.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.