Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1996SC2 L4-1.9L DOHC VIN 7REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCRANKSHAFT POSITION SENSORSERVICE AND REPAIR
1996 Saturn SC2 L4-1.9L DOHC VIN 7
Crankshaft Position Sensor: Service and Repair
1996 Saturn SC2 L4-1.9L DOHC VIN 7SECTION Service and Repair
Crankshaft Position Sensor.:
REMOVAL
1. Disconnect negative battery cable.
CAUTION MAKE SURE THE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED PRIOR TO LIFTING.
2. Jack or raise vehicle.
3. Disconnect electrical connector from CKP sensor.
4. Remove attachment bolt and CKP sensor.
INSTALLATION
1. Lubricate O-ring with clean engine oil.
2. Install CKP sensor in engine block.
3. Install CKP sensor attachment bolt.
- Torque 9 Nm (80 lb in)
4. Connect electrical connector to the CKP sensor. Push in until a click is heard and pull back to confirm a positive engagement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.