Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1996SC2 L4-1.9L DOHC VIN 7REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYSERVICE AND REPAIRTRANSMITTER BATTERY REPLACEMENT
1996 Saturn SC2 L4-1.9L DOHC VIN 7
Transmitter Battery Replacement
1996 Saturn SC2 L4-1.9L DOHC VIN 7SECTION Transmitter Battery Replacement
NOTICE: If the transmitter(s) won't work, perform the "RKE SYSTEM CHECK" before replacing the battery. Also, before replacing the battery ill the transmitter(s), make sure that the battery is touching both the negative and positive contacts inside the transmitter(s).
For battery replacement, use a Panasonic type CR203: 3-volt battery, or equivalent.
NOTICE: Use of the wrong battery size may damage the transmitter. The correct battery can be obtained by calling Digikey 1-800-344-4539
To replace the battery, perform the following procedures:
Replacing Battery In Transmitter:
1. Use a small coin, or flat-head screwdriver, to separate bottom of transmitter from top.
Replacing Battery In Transmitter:
2. Remove battery and replace with new battery.
Replacing Battery In Transmitter:
3. Make sure positive (+) side of battery faces down.
4. Snap top and bottom sides of transmitter together.
5. Test the operation of transmitter with the vehicle.
If the transmitter does not work, try synchronizing your transmitter with your remote control door lock (RKE) module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.