Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20049-5 LINEAR (9600) L4-2.3L TURBO (2.3T)REPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSTRACTION CONTROL MODULEDESCRIPTION AND OPERATIONABS WITH TCS ONLYCONTROL MODULE GROUND
2004 Saab 9-5 Linear (9600) L4-2.3L Turbo (2.3t)
Control Module Ground
2004 Saab 9-5 Linear (9600) L4-2.3L Turbo (2.3t)SECTION Control Module Ground
Control module ground
Control module ground
The control module is grounded via pin 19 to grounding point G2.
The pump motor is grounded through pin 16 to grounding points G30 and G40 (G42 RHD).
Diagnostics
If there is a break in the circuit to pin 19, the TCS and ABS functions will be disabled and the warning lamps for ABS, brakes and TCS OFF will light up as well as the central warning lamp. Communication with the diagnostic tool is not possible.
If there is a break in the circuit to pin 16, diagnostic trouble code C2465 will be set, the TCS and ABS functions will be disabled and the warning lamps for ABS, brakes and TCS OFF will light up as well as the central warning lamp.
Control module ground
The control module is grounded via pin 19 to grounding point G2.
The pump motor is grounded through pin 16 to grounding points G30 and G40 (G42 RHD).
Diagnostics
If there is a break in the circuit to pin 19, the TCS and ABS functions will be disabled and the warning lamps for ABS, brakes and TCS OFF will light up as well as the central warning lamp. Communication with the diagnostic tool is not possible.
If there is a break in the circuit to pin 16, diagnostic trouble code C2465 will be set, the TCS and ABS functions will be disabled and the warning lamps for ABS, brakes and TCS OFF will light up as well as the central warning lamp.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.