Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20009-3 CONVERTIBLE (9400) L4-2.0L TURBO (B205)REPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL MODULEDESCRIPTION AND OPERATIONCONTROL MODULE INPUTS, OUTPUTS, POWER SUPPLY
2000 Saab 9-3 Convertible (9400) L4-2.0L Turbo (B205)
Control Module Inputs, Outputs, Power Supply
2000 Saab 9-3 Convertible (9400) L4-2.0L Turbo (B205)SECTION Control Module Inputs, Outputs, Power Supply
Control Module Inputs
- Power supply +54
- Ground
- Brake lights switch (29)
- Clutch pedal switch (133)
- Brake pedal switch (134)
- Switch (141)
- Vehicle speed, lead from ABS (547)
Control Module Outputs
- CRUISE lamp in main instrument unit (540b)
- Communication with Trionic/Motronic (430/505)
Control Module
The control module is located on the right to the rear of the engine bay. It is connected to the system's constituent components by a 10-pin connector.
The control module is supplied with current from the +54 circuit via pin 6 (F) and grounded via pin 5 (E).
Control module communication with the ABS control module: a speed signal is received from the LH front wheel on pin 10 (K) and Trionic is advised via pin 9 (J) when the cruise control is activated.
An electric stepping motor in the control module operates the cruise control cable mechanically. It pulls or releases the cruise control cable connected to the throttle body, depending on the difference between requested and actual speed.
Control Module Power Supply
+54
Current from the +54 circuit is supplied to the control module, terminal 6 (F), when the ignition switch is in the ON position.
If the control module is not supplied with current it will be inoperative.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.