Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSRENAULT198518I/SPORTWAGON L4-2165CC 2.2LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTHROTTLE POSITION SENSORSERVICE AND REPAIRTHROTTLE POSITION SENSOR (POTENTIOMETER), REPLACE
1985 Renault 18I/Sportwagon L4-2165cc 2.2L
Throttle Position Sensor (Potentiometer), Replace
1985 Renault 18I/Sportwagon L4-2165cc 2.2LSECTION Throttle Position Sensor (Potentiometer), Replace
Fig. 6 Load potentiometer installation:
1. Remove air cleaner, as needed, and disconnect electrical connector between potentiometer and computer.
2. Remove 2 retaining screws and the potentiometer, Fig. 6
3. Reverse procedure to install and adjust potentiometer as outlined in ``Checks And Adjustments.''
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.