Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSRENAULT198518I/SPORTWAGON L4-2165CC 2.2LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTHROTTLE FULL CLOSE SWITCHADJUSTMENTS
1985 Renault 18I/Sportwagon L4-2165cc 2.2L
Throttle Full Close Switch: Adjustments
1985 Renault 18I/Sportwagon L4-2165cc 2.2LSECTION Adjustments
Refer to ``Inline 4 Cylinder Engine Tune Up'' for ignition timing, idle speed and idle air/fuel mixture adjustments.
THROTTLE POSITION SWITCH
1. On Alliance and Encore models, remove throttle body to gain access to attaching screws.
2. On all models, loosen switch attaching screws.
3. With throttle plate against stop, slowly rotate throttle position switch in direction of throttle plate opening until inner stop can be felt.
4. Tighten two attaching screws.
5. On Alliance and Encore models, install throttle body.
THROTTLE POSITION SWITCH
1. On Alliance and Encore models, remove throttle body to gain access to attaching screws.
2. On all models, loosen switch attaching screws.
3. With throttle plate against stop, slowly rotate throttle position switch in direction of throttle plate opening until inner stop can be felt.
4. Tighten two attaching screws.
5. On Alliance and Encore models, install throttle body.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.